Saturday, October 16, 2010

Baby Bath Mitt Tutorial



You will need
  • The pattern (click on the picture below and then print it - I hope it works! - or just draw your own by tracing around an oven mitt)
  • Terry toweling. I used a hand towel I got from Kmart for $1, and got two bath mitts out of it (but if I cut each piece separately instead of two at a time, I could get 3). Recycle a towel you have at home or pick up a fun coloured towel from the op shop or a discount store like Red Dot.
  • 7 x 20cm rectangle of ribbing (you can use elastic and make a casing instead if you prefer).
 1. Cut out your pattern pieces.

2. Lay your pattern pieces one on top of the other, matching up all the edges. Starting at the bottom (wrist end) on the thumb-less side, sew about two-thirds of the way up (the stopping point is marked on the pattern with an arrow, and in the picture below with a pin). Don't go all the way around, make sure you stop before you get the the curve.

3. Open out your bath mitt and lay it flat, right side up.

4. Fold your ribbing in half length-ways, and line up the raw edge with the wrist edge of the bath mitt (if you're using elastic and casing, you'd do this with your casing material - fold it in half, wrong sides together and line up the edges like you would with the ribbing).

5. Sew along the raw edge, stretching the ribbing as you go by pulling it towards you as much as you can while sewing it. This will gather in the wrist a little bit and make a snug, comfy wrist band (if you're using the casing/elastic, just sew it normally, then attach your elastic to one end. Thread it through, pull it out as much as needed to gather it in, then sew the other end into place). Overlock this edge.

6. Place the mitt right sides together again, and starting from where you left off, finish sewing all the way around the edge of the mitt. Overlock the entire edge. Its easier to overlock if you change the settings so it doesn't cut off the excess material as it overlocks, this way you'll be able to get around the difficult curves without accidentally cutting into something.

7. Turn your bath mitt right side out, and put your baby in the bath so you can use your new bath mitt!






      0 comments:

      Post a Comment